INTSUPERMAI Magnetic Chuck Fine Pole Permanent Magnetic Chuck Powerful Rectangular Chuck for Grinding Machine Lathe Magnets (8X16 Inch)

Instructions: Put the workpiece on the suction table, and then insert the wrench into the shaft hole to turn clockwise180°, the workpiece can be sucked for processing. The workpiece is completed, the wrench can be inserted into the shaft hole to turn counterclockwise 180 °, you can remove the workpiece.  Maintenance: Sucker should be wiped clean before use to avoid scratching the surface, after using, the surface should be coated with oil to prevent corrosion. Use of ambient temperature: -40 ℃ -50 ℃. Do not knock, to prevent magnetic reduction. Panel with special treatment, no leakage, to prevent corrosion of cutting fluid. To prolong service life of the disk, it can be placed on the cutting fluid for storage. Six-surface fine grinding processing, the sucker can be used in vertical direction on the wire cutting machine cutting. High-performance magnetic steel disk, with suction, almost no remanence. Suction can be 120N / cm2.  Application: The magnetic chuckcan be used for processing various magnetic conduction work pieces. For surface grinder, tool grinder, EDM and other applications. Thin & light weight work piece are ideally suitable because of fine-pitched magnetic poles.  Item included: 1 x Hex wrench 4 x Mounting tabs 1 x Magnetic chuck

• 𝐌𝐀𝐈𝐍 𝐏𝐀𝐑𝐀𝐌𝐄𝐓𝐄𝐑𝐒 -- Table Size: 8X16X1.7in/200X400X45mm (Width x Length x Height); Suction: 100-120 N/cm2 ; Temperature: -40 ℃ - 50 ℃.
• 𝐔𝐍𝐈𝐅𝐎𝐑𝐌 𝐌𝐀𝐆𝐍𝐄𝐓𝐈𝐂 𝐅𝐎𝐑𝐂𝐄 -- Its magnetic pole spacing is fine, the magnetic force distribution is uniform, the suction is large, and there is almost no remanence. The effect is especially obvious when the workpiece is thin and small.
• 𝐅𝐈𝐍𝐄 𝐏𝐑𝐎𝐂𝐄𝐒𝐒𝐈𝐍𝐆 -- It applies six-surface fine grinding processing, the sucker can be used in vertical direction on the wire cutting machine cutting. And it can directly install kinds of clamps on the magnetic chuck.
• 𝐍𝐎 𝐒𝐓𝐈𝐌𝐔𝐋𝐀𝐓𝐈𝐎𝐍 & 𝐍𝐎 𝐋𝐄𝐀𝐊𝐀𝐆𝐄 -- Its panel is specially treated to prevent cutting fluid corrosion and effectively extend the service life of the disk. It can work in cutting fluid for a long time.
• 𝐖𝐈𝐃𝐄 𝐀𝐏𝐏𝐋𝐈𝐂𝐀𝐓𝐈𝐎𝐍 -- It uses a simple mechanical switch. When ON / OFF is switched, the plane accuracy of the magnetic surface remains unchanged. Its operation is also very simple. The magnetic chuck can be used for processing various magnetic conduction work pieces, which is suitable for surface grinder, tool grinder, EDM and other applications.